Jump to content

OpenScope MZ AWG1 is broken


Recommended Posts

I am teaching a course using the OpenScope MZ and after just a few weeks, 8 of the 60 students have broken their (initially working) device.  In nearly all cases, the problem is that AWG1 only puts out a DC voltage (usually 2-3 V) regardless of what is specified in WaveForms Live (and even immediately after boot up).  Is this a known failure mode?  Is there any way to recover the device?

Link to comment
Share on other sites

Hi @KevinStenson,

I haven't seen this particular failure before. The only way I can find to output a DC voltage that high is through the DC Out 1 (the red wire). The WaveGen (at least as per the DC output setting) isn't able to go above 1.5V. I will ask the engineer more familiar with WaveForms Live about this.

Thanks,
JColvin

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...