riscy00 Posted September 13, 2020 Share Posted September 13, 2020 I have discovery board (not 2) is there way to issue command to setup dac for sine wave and gpio in sequence pattern via uart or Usb via com port? If so how this be done? Link to comment Share on other sites More sharing options...
JColvin Posted September 15, 2020 Share Posted September 15, 2020 Hi @riscy00, I have moved your question to a more appropriate section of the forum. Thanks, JColvin Link to comment Share on other sites More sharing options...
attila Posted September 15, 2020 Share Posted September 15, 2020 Hi @riscy00 The instruments beside WF app can be controlled with custom apps/scripts using the WF SDK, LabView AD toolkit, MATLAB DAQ toolbox You can also use the dwfcmd app to control it. Link to comment Share on other sites More sharing options...
riscy00 Posted September 15, 2020 Author Share Posted September 15, 2020 So there no access to COM based interface to issue with receives message. Link to comment Share on other sites More sharing options...
attila Posted September 15, 2020 Share Posted September 15, 2020 Hi @riscy00 The device does not use COM based interface but proprietary high-speed parallel communication. Link to comment Share on other sites More sharing options...
Question
riscy00
I have discovery board (not 2) is there way to issue command to setup dac for sine wave and gpio in sequence pattern via uart or Usb via com port? If so how this be done?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.