I am using a Corz Z7 (Zynq part: XC7Z010-1CLG400). I was trying to reconfigure the FTDI using FT_PROG EEPROM programming utility in order to use the second channel of the chip as SPI rather than UART, while doing so, I accidentally ended up erasing the chip and now my board is not being recognized by Vivado. I am using Vivado 2020.1. I wanted to know is there any way I can reset the FTDI chip back to the factory version otherwise my board has become useless, the only way I can boot it now is via SD Card which is not useful while developing new projects.
Question
Soham Kulkarni
Hello,
I am using a Corz Z7 (Zynq part: XC7Z010-1CLG400). I was trying to reconfigure the FTDI using FT_PROG EEPROM programming utility in order to use the second channel of the chip as SPI rather than UART, while doing so, I accidentally ended up erasing the chip and now my board is not being recognized by Vivado. I am using Vivado 2020.1. I wanted to know is there any way I can reset the FTDI chip back to the factory version otherwise my board has become useless, the only way I can boot it now is via SD Card which is not useful while developing new projects.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.