• 0

Zybo Z7-20 Tutorial Help



I was going through the tutorial at https://reference.digilentinc.com/learn/programmable-logic/tutorials/zybo-getting-started-with-zynq/start and ran into the following issue when trying to run the program on hardware. When I proceed, it goes through, but the program does not do anything. I am unable to activate the LEDs with the switches and the tera term does not get a message when a button is pressed. Could this be the issue of the attached warning?


Link to post
Share on other sites

2 answers to this question

Recommended Posts

  • 0


Did you select the correct FPGA or board from the boards? This tutorial is made for the original Zybo. It should work but you had to select your own board. Zybo Z7-20 in your case, or if you worked with FPGA parts


From the warning you received it seems to me that you selected the wrong part. 



Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now