I was going through the tutorial at https://reference.digilentinc.com/learn/programmable-logic/tutorials/zybo-getting-started-with-zynq/start and ran into the following issue when trying to run the program on hardware. When I proceed, it goes through, but the program does not do anything. I am unable to activate the LEDs with the switches and the tera term does not get a message when a button is pressed. Could this be the issue of the attached warning?
Question
rpudelko
Hello,
I was going through the tutorial at https://reference.digilentinc.com/learn/programmable-logic/tutorials/zybo-getting-started-with-zynq/start and ran into the following issue when trying to run the program on hardware. When I proceed, it goes through, but the program does not do anything. I am unable to activate the LEDs with the switches and the tera term does not get a message when a button is pressed. Could this be the issue of the attached warning?
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.