Frequency of FCLK_0 in arty-z7-20

[amolina]

Hi, recently i have bought the arty-z7-20 which it has a frequency clock of 125 MHz, and when I configure the ZYNQ-7000 with configuration options of this board in the PL clocks the frequency of FCLK_0 is the 100 MHz. Can I put the frequency that I want? Have I set the frequency of FCLK_0 to 125 MHz? I am not sure that frequency establish. Thanks in advantage.

[JColvin]

Hi @amolina,

I apologize for the delay. You can change the FCLK_0 frequency if you want to; the only requirement is that as long as the timing needs of your design and any requirements of any IP that the clock might be connected to are satisfied.

Thanks,
JColvin

[amolina]

Don't worry, very thanks for the reply.