I wish to drive the JTAG signals by fitting a connector in J13 on the card. Can you confim that if I power the Cora 7S card via the external psu with 5V and leave the USB shown as "3 Shared USB JTAG / UART port" in the reference manul the FTDI chip will not cause contention on the signals.
I am unable to confirm this as I guess that the circuit for this section is on the page which has been left blank.
Question
Testcards101
I wish to drive the JTAG signals by fitting a connector in J13 on the card. Can you confim that if I power the Cora 7S card via the external psu with 5V and leave the USB shown as "3 Shared USB JTAG / UART port" in the reference manul the FTDI chip will not cause contention on the signals.
I am unable to confirm this as I guess that the circuit for this section is on the page which has been left blank.
Thanks
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.