Orycho Posted June 4, 2020 Share Posted June 4, 2020 I bought the impedance analyzer and receive it today. When I try to insert a component into this analyzer, I found I cannot lock it into that socket? So, how to use that socket on the analyzer to lock my component? Thanks. Link to comment Share on other sites More sharing options...
attila Posted June 4, 2020 Share Posted June 4, 2020 Hi @Orycho Press down the orange handles while pushing the DUT in. Also aim the DUT legs toward the AD2 since the tip could block midway on the handle side. If you want to change the DUT often better use some shot flying wires. Link to comment Share on other sites More sharing options...
Orycho Posted June 4, 2020 Author Share Posted June 4, 2020 Thank you. It works. ? Link to comment Share on other sites More sharing options...
RichSCorp Posted April 10, 2021 Share Posted April 10, 2021 How would you test a surface mount component? Link to comment Share on other sites More sharing options...
attila Posted April 12, 2021 Share Posted April 12, 2021 Hi @RichSCorp You can use some wires. When working with semiconductors attached use low voltage and offset, take care of polarity. Testing a 20pF capacitor on board with some series resistors in parallel: Link to comment Share on other sites More sharing options...
Question
Orycho
I bought the impedance analyzer and receive it today.
When I try to insert a component into this analyzer, I found I cannot lock it into that socket?
So, how to use that socket on the analyzer to lock my component? Thanks.
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.