I am having an issue with WaveForms identifying my AD2. In the device manager instead of showing up as Discovery2, it shows up as "examplenotlaser." The voltage remains around 4.84V and current is about 340 mA in the system monitor. I am using both the USB and the aux cord with the settings allowing the USB power to always be on.
I am using a VM (Fusion 11.5) on a mac (Catalina 10.15.3) to run waveforms in Windows 10. However, I also tried using waveforms directly on my mac with the same result. Windows seems to detect the device which is shown in one of the pictures below.
Question
jwallin
I am having an issue with WaveForms identifying my AD2. In the device manager instead of showing up as Discovery2, it shows up as "examplenotlaser." The voltage remains around 4.84V and current is about 340 mA in the system monitor. I am using both the USB and the aux cord with the settings allowing the USB power to always be on.
I am using a VM (Fusion 11.5) on a mac (Catalina 10.15.3) to run waveforms in Windows 10. However, I also tried using waveforms directly on my mac with the same result. Windows seems to detect the device which is shown in one of the pictures below.
Any help is greatly appreciated
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.