I need to control a device, using LabVIEW to give command to signal generator(Agilent 33522A), which can make the device switching voltage(amplitude)with short time(10~50ms).
I have a problem:
Where to put the time command to make the time can be adjusted?
Or indicate whether my code is proper for my requirement.
Question
Stanforthis
I need to control a device, using LabVIEW to give command to signal generator(Agilent 33522A), which can make the device switching voltage(amplitude)with short time(10~50ms).
I have a problem:
Where to put the time command to make the time can be adjusted?
Or indicate whether my code is proper for my requirement.
Agilent 33522A Control_2.vi
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.