Stuck in Demo Mode in the Waveforms Scope

[Mark Dunkle 0]

How do I exit Demo Mode in the Waveforms Scope?  See attached screen shot

Demo mode.pdf

[JColvin 341]

Hi @Mark Dunkle,

If you attach a supported board (such as the Analog Discovery 2) a pop-up will appear asking you if you would like to connect to it; this will take you out of demo mode.

If this pop-up does not appear, you can click on the "Discovery 2 DEMO" box that is in the bottom right hand corner of the GUI, you will be able to select your attached hardware from there (or choose a different board to demo).

If you are are looking to test out the other tools besides the Scope, click on the Welcome tab with the green plus sign (just above the "File") button.

Let me know if you have any questions about this.

Thanks,
JColvin

[Mark Dunkle 0]

Turns out the problem was that the USB connector was not fully seated in the jack.