network analyzer analyzer to achieve bod plot

[tauquir_iqbal]

i want to achieve network response of buck convector using dsp controller. 

i am confused where i should put waveform generator. 

The signal for the switch is coming from DSP. so the one of the oscilloscope can be connected to the output voltage. and where should i connect the other oscilloscope and waveform generator.

[JColvin]

Hi @tauquir_iqbal,

Are you using the Analog Discovery 2 like in your previous posts? Or more specifically, is this question a direct continuation to the one you had in this thread?

Thanks,
JColvin

[tauquir_iqbal]

yes i am using the same however i didn't get my answer. therefore, i had to ask again in new thread.