I am having a hard time using Labview to set up the digital output drive mode to be the same as push-pull mode within the Waveforms GUI. Seems like when using Labview, when an Analog Explorer 2 pin is initialized as an output, the output goes to high Z.
I need it to go to 3.3V (or whatever the highest digital voltage is) or 0V when needed.
Question
Sbacica
Hello,
I am having a hard time using Labview to set up the digital output drive mode to be the same as push-pull mode within the Waveforms GUI. Seems like when using Labview, when an Analog Explorer 2 pin is initialized as an output, the output goes to high Z.
I need it to go to 3.3V (or whatever the highest digital voltage is) or 0V when needed.
Thanks for your help.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.