JTAG-SMT2

[Wyorin]

I have developed a test system using a Xilinx Spartan 6 and the Digilent JTAG-SMT2 programming module. I can program the device OK but if I include an Chipscope ILA and run the analyser the ILA is not found. I know that the ILA is in the build because I have looked for it using ISE14.7 FPGA Editor. I have turned the JTAG clock speed right down to 125 kHz, but still no joy. Any thoughts?

[jpeyron]

Hi @Wyorin,

Since you are able to initialize the scan chain and configure the Spartan 6 i would first look into the Chipscope ILA. I have not used the Chipscope ILA in ISE.  This AR looks to be helpful for trouble shooting the Chipscope. 

best regards,

Jon

[Wyorin]

On ‎8‎/‎16‎/‎2019 at 10:13 PM, jpeyron said:

Hi @Wyorin,

Since you are able to initialize the scan chain and configure the Spartan 6 i would first look into the Chipscope ILA. I have not used the Chipscope ILA in ISE.  This AR looks to be helpful for trouble shooting the Chipscope. 

best regards,

Jon

Hi Jon

Thanks for the reply, much as I expected. I have posted same question on Xilinx Forum and still awaiting response.