Larry Standage Posted August 13, 2019 Share Posted August 13, 2019 Hi everyone, I know that, in order to use the FTDI chip as a JTAG programmer, that one of the pins on the FTDI has to be configured to allow the connection to the part. For UrJTAG, how does one change the state of the pins on the FTDI chip? Thanks! Link to comment Share on other sites More sharing options...
JColvin Posted August 15, 2019 Share Posted August 15, 2019 Hi @Larry Standage, I'm not familiar with UrJTAG specifically, but based on the MIPS Bus Blaster Guide that discusses how to connect and use EJTAG and OpenOCD with the JTAG port on the Wi-FIRE and they don't seem to use any special settings, so I'm not certain you would need any particular settings, unless I am misunderstanding how UrJTAG needs to work. Thank you, JColvin Link to comment Share on other sites More sharing options...
Question
Larry Standage
Hi everyone,
I know that, in order to use the FTDI chip as a JTAG programmer, that one of the pins on the FTDI has to be configured to allow the connection to the part. For UrJTAG, how does one change the state of the pins on the FTDI chip?
Thanks!
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.