We have a custom board which requires use of an FTDI FT4232H Quad HS USB-UART/FIFO IC chip (VID: 0403, PID: 6011). The JTAG interface is on channel A, SPI/I2C interface is configured for channel B, VCP on channel C, and GPIO on channel D.
Is there any way we can enable Adept support for this FTDI part?
Question
Josh K
Hi,
We have a custom board which requires use of an FTDI FT4232H Quad HS USB-UART/FIFO IC chip (VID: 0403, PID: 6011). The JTAG interface is on channel A, SPI/I2C interface is configured for channel B, VCP on channel C, and GPIO on channel D.
Is there any way we can enable Adept support for this FTDI part?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.