Djsnzheusj Posted July 8, 2019 Share Posted July 8, 2019 Hello guys, Im still starting off with FPGA's and i wonder if any one can point me to where the XDC file can be obtained for my board ARTY A7-35 REV E. the only master file i find is for the REV.D will it make a difference ? Thank you so much in advance. Link to comment Share on other sites More sharing options...
Bianca Posted July 8, 2019 Share Posted July 8, 2019 Hi @Djsnzheusj, The XDC for D.0 will work. We made a spin for the power supplies. Nothing in the FPGA configuration was affected by the new PCB spin. Regards, Bianca Link to comment Share on other sites More sharing options...
Question
Djsnzheusj
Hello guys,
Im still starting off with FPGA's and i wonder if any one can point me to where the XDC file can be obtained for my board ARTY A7-35 REV E. the only master file i find is for the REV.D will it make a difference ?
Thank you so much in advance.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.