Can't get any output from my FPGA when programming it.

[mptcultist]

Hi, I've been trying to follow the microblaze servers tutorial for my Genesys 2 board, but after I program it, the uart is empty, it never connects to ethernet,  and eventually it just disconnects from usb and gets very paperweight-y. The demo runs, so I don't think the board is defective, but I was wondering if anyone had any idea what was going wrong.

[jpeyron]

Hi @mptcultist,

What text is being sent through the USB UART COM Port and the telnet on the Serial terminal emulator? Please attach screen shots.

What speed are you setting the phy_link_speed?

best regards,

Jon

[mptcultist]

18 minutes ago, jpeyron said:

Hi @mptcultist,

What text is being sent through the USB UART COM Port and the telnet on the Serial terminal emulator? Please attach screen shots.

What speed are you setting the phy_link_speed?

best regards,

Jon

Absolutely nothing, that's the issue. The link speed is set to 100mbps.

[jpeyron]

Hi @mptcultist,

Are you able to run the Getting started with Microblaze  tutorial working?

best regards,

Jon

[mptcultist]

36 minutes ago, jpeyron said:

Hi @mptcultist,

Are you able to run the Getting started with Microblaze  tutorial working?

best regards,

Jon

Yes, I can.

[jpeyron]

Hi @mptcultist,

Please attach screen shots of your vivado block design along with your SDK with the HW_Platform expanded.

best regards,

Jon