I have bougth a Zybo board to explorer new Xilinx chip plus FPGA Zynq.
Now I started to develop my PCB owner, following the wiring diagram of Zybo reference. I started to design the PCB but I have doubts on the routing of DDR3 memory. I was wondering if it was possbile to have theĀ files Gerber / CAD / PCB / Allegro to carry out an exploration positioning, length and configuration of the slopes.
Question
debugasm
I have bougth a Zybo board to explorer new Xilinx chip plus FPGA Zynq.
Now I started to develop my PCB owner, following the wiring diagram of Zybo reference. I started to design the PCB but I have doubts on the routing of DDR3 memory. I was wondering if it was possbile to have theĀ files Gerber / CAD / PCB / Allegro to carry out an exploration positioning, length and configuration of the slopes.
Can you provide these files ?
Thanks very much.
Best Regards,
debugasm
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.