CORA J1 position and header heights

[Erickson]

 I have a new design coming along that will need to use I/O pins on the (normally not populated) J1 connector.  I don't have easy access to a CORA at the moment, so am looking for X and Y offsets from J1 to the J4/J5 connectors.  Also, are there part numbers or height measurements available for the normally populated headers to help in selecting a part with appropriate dimensions to install in the J1 position?

Thanks!

[jpeyron]

Hi @Erickson,

I believe these are the measurement you are looking for:

Top edge of the Cora Z7 10 to the middle of J1 is 1.39 mm
Top edge of the Cora Z7 10 to the top of J5 is 5.95 mm
From the middle of pin 16 on J1 to the right edge of J5 is 2.54 mm

2x8 for J5

Best regards,

Jon

[JColvin]

Hi @Erickson,

As an additional reference, here is a link to the matching component that would go with the Arduino styled headers for the unloaded J1 (digikey link).

Thanks,
JColvin