Configuring microZED 7010 for PMOD CAN module

[veca2]

Hi,

Using a microZED 7010 board and trying to setup a PMOD CAN module from Digilent.

I followed this setup: 

https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start

Vivado 2018.2

When selecting the board microZED 7010 in my project setup, there is no PMOD connector available in board view to select. This seems to be missing from the board file.

In PL, I setup the PMOD CAN IP and need to connect the PMOD interface to the PMOD pins. These are available on MIO. 

The issue: I would need to connect MIO pins 0, 9-15 to this PMOD CAN IP. However, in I/O settings, these physical pins are not available. Adding them in constraints is not possible neither.

The PMOD pins are "locked" to the MIO bus.

Is there a way I can re-araange the MIO pins 0, 9-15 to my PMOD CAN IP block? This should be possible, but without the appropriate board file, I can't get it to work.

There have been several topics about this issue, but nothing seems to be expalined when using PMOD pins from PL on a microZED board;

Thanks for inputs!

 

[jpeyron]

Hi @veca2,

Welcome to the digilent forums!

Here is a forum thread that should be helpful with getting the PmodCAN working on the MicroZED development board.

best regards,

Jon