I have a Digilentinc Genesys 2 board, my project needs to communicate between a PC and the FPGA. Because the data needs to travel at high speed I use the FT2232H-chip. I already can send data from the pc to the FPGA. But sending data from the FPGA to the PC isn't possible. My code(Verilog and Labview) works with a custom board with the same FT2232H-chip but not with the Genesys2. The problem is that the USB_TXEN doesn't go LOW.
Is it possible that I need to set the USB-jumper(s) on another position?
Does anybody know another source of this problem?
Question
Jensen
Hello,
I have a Digilentinc Genesys 2 board, my project needs to communicate between a PC and the FPGA. Because the data needs to travel at high speed I use the FT2232H-chip. I already can send data from the pc to the FPGA. But sending data from the FPGA to the PC isn't possible. My code(Verilog and Labview) works with a custom board with the same FT2232H-chip but not with the Genesys2. The problem is that the USB_TXEN doesn't go LOW.
Is it possible that I need to set the USB-jumper(s) on another position?
Does anybody know another source of this problem?
With friendly regards,
Jensen
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.