MIPI D-PHY and CSI-2

[Sduru]

Hi everyone,

I am dealing with MIPI CSI-2 RX and D-PHY RX IPs  which are open source IPs by Digilent. Where is the latest versions of those IPs? Is there new versions of those which are compatible with Vivado 2018.3? 

Many thanks...

[Sduru]

Dear All,

I am asking this question because I cannot generate bitstream for my project like in the following:

I am using Zybo Z7 and PCAM OV5640 CMOS with Vivado 2018.3 version. I just wanna put ILA function and observe digital image data captured by MIPI CSI-2. But, I am getting the following errors:

[Common 17-55] 'get_property' expects at least one object. Resolution: If [get_] was used to populate the object, check to make sure this command returns at least one valid object.

[BD 41-1273] Error running post_propagate TCL procedure: ERROR: [Common 17-55] 'get_property' expects at least one object. ::digilentinc.com_ip_MIPI_D_PHY_RX_1.3::post_propagate Line 6

Does any body know the root causes of this failure? Is it related to Vivado version, or Digilent MIPI IPs version or my block design? 

Many thanks..

Cheers..

[jpeyron]

Hi @Sduru,

Sorry for the late response. We we out of the office yesterday and some of last week. 

I have responded to your question on your other post here.

best regards,

Jon