Zybo Z7 Board Using Raspberry Pi Camera Module V2-8 Megapixel,1080p

[Sameer120]

Hello ,

I am using Zybo Z7-20 Board and I am using Digilent PCAM 5C on board for doing some Image Processing.

I want to know, can I use Raspberry Pi Camera Module V2-8 Megapixel,1080p(https://www.raspberrypi.org/products/camera-module-v2/) with this Zybo Z7-20 Board using MIPI interface.

I know the CMOS Sensors are different, but want to know if its compatiblie as its MIPI interface( I am just thinking like a USB Camera of any make works on Linux)

Please confirm if I can use this Camera as is or need to modify any drivers, if yes then any suggestions on modifications.

Thanks & Regards

Sameer 

[jpeyron]

Hi @Sameer120,

Here is a raspberrypi forum thread that discusses the compatibility between mipi-dsi and mipi-csi-2. It sounds like the sensor might work but there would be additional issues. Also we do not have drivers for this sensor. You would have to create these custom drivers as well.

cheers,

Jon 

[xc6lx45]

You might have a look at Trenz Electronics "Zynqberry". I think they managed to get one of the cameras to work (not sure). What I do remember is that the board has some custom resistor circuitry to additional pins for the required low-speed signaling.

[Sameer120]

Hi Jon,

Thanks for your input and providing links.

Hi Xc6lx45,

Thanks for your refernce of Trenz Electronics "Zynqberry", will take detailed look.

Thanks

Sameer