I am trying to set up the JTAG-SMT3-NC with openOCD. In order to setup the ftdi driver I need the pin mapping.
I understand that the internal schematic of the SMT3 is not publicly available, is it instead possible to get a table that maps the ft2232 GPIO onto the ouput pins?
Question
RussGlover
Hi there,
I am trying to set up the JTAG-SMT3-NC with openOCD. In order to setup the ftdi driver I need the pin mapping.
I understand that the internal schematic of the SMT3 is not publicly available, is it instead possible to get a table that maps the ft2232 GPIO onto the ouput pins?
Similair to this post for the SMT2:
Thank you for your help.
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.