I'm developing a design for the ZyBo and I'm using JTAG to communicate a PC with a microblaze. I'm using the onboard FT2232HQ to achieve this, but it is configured as UART -> Virtual COM Port and 245 FIFO -> D2XX Direct, so I can't see the JTAG connection as a COM port in the PC (which is what I need). I know that this can be changed using FT Prog, but I've seen that a lot of people had problems connecting the board with Vivado after changing the FT2232 configuration.
Is it safe to make changes in the FT2232 configuration?
Question
elizegi
Hi,
I'm developing a design for the ZyBo and I'm using JTAG to communicate a PC with a microblaze. I'm using the onboard FT2232HQ to achieve this, but it is configured as UART -> Virtual COM Port and 245 FIFO -> D2XX Direct, so I can't see the JTAG connection as a COM port in the PC (which is what I need). I know that this can be changed using FT Prog, but I've seen that a lot of people had problems connecting the board with Vivado after changing the FT2232 configuration.
Is it safe to make changes in the FT2232 configuration?
Thanks,
Xabier
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.