• 0

Recommended Protection Circuit for Cmod A7


I'm preparing to embed a Cmod A7 on a PCB and I want to provide similar circuit protection for some of its pins to those found on a Pmod output. I looked at the schematics for the Basys3 and found a 200 Ohm series resistor on each output pin and a zener diode directly from pin to ground. I  have two concrete questions:

1. Just to confirm, the Zener voltage should be 3.4V, right?

2. What power does Digilent recommend for the 200 Ohm resistor?



Screen Shot 2019-01-02 at 10.34.00 AM.png

Link to post
Share on other sites

2 answers to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now