I'm preparing to embed a Cmod A7 on a PCB and I want to provide similar circuit protection for some of its pins to those found on a Pmod output. I looked at the schematics for the Basys3 and found a 200 Ohm series resistor on each output pin and a zener diode directly from pin to ground. I have two concrete questions:
1. Just to confirm, the Zener voltage should be 3.4V, right?
2. What power does Digilent recommend for the 200 Ohm resistor?
Question
dfergenson
I'm preparing to embed a Cmod A7 on a PCB and I want to provide similar circuit protection for some of its pins to those found on a Pmod output. I looked at the schematics for the Basys3 and found a 200 Ohm series resistor on each output pin and a zener diode directly from pin to ground. I have two concrete questions:
1. Just to confirm, the Zener voltage should be 3.4V, right?
2. What power does Digilent recommend for the 200 Ohm resistor?
Thanks.
-David
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.