Ahmed Alfadhel Posted December 26, 2018 Share Posted December 26, 2018 Hi , I am confronting dimensions mismatch in my design . So could I solve this issue by manipulating the dimension of PmodDA3_0 (pin : AXI_LITE_GPIO_wdata[31:0] ) , and keeping the rest of my design untouched ? If yes , how ? If no, what should I do? Kindly see the attached picture . Kind Regards Link to comment Share on other sites More sharing options...
jpeyron Posted December 28, 2018 Share Posted December 28, 2018 Hi @Ahmed Alfadhel, My understanding is that the AXI bus is has a width of 32 bits. I would adjust you multiplier to width to 32 to resolve the mismatch. thank you, Jon Link to comment Share on other sites More sharing options...
Question
Ahmed Alfadhel
Hi ,
I am confronting dimensions mismatch in my design . So could I solve this issue by manipulating the dimension of PmodDA3_0 (pin : AXI_LITE_GPIO_wdata[31:0] ) , and keeping the rest of my design untouched ? If yes , how ? If no, what should I do?
Kindly see the attached picture .
Kind Regards
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.