I have some sort of target conflict when using my Digital Discovery and my Xilinx ZCU-104 board. The Xilinx board will not properly reset and detect from the SDK tool (Hardware Manager works, but I have to run my project from SDK)
I have not had any problems with conflict when using my Zybo Z7 with the Digital Discovery.
At this time, to get my target running I have to disconnect the Digital Discovery then Initialize the ZCU board. After it has started I can reconnect my Digital Discovery and it works as expected.
This workaround is not very good, plugging and unplugging hardware all the time. Also, the digital inputs (from ZCU to DD instrument) will partially back-power the Digital Discovery, so I have to disconnect all incoming signals to actually get the Digital Discovery to initialize and connect to the Waveforms tool.
If you could offer some suggestion or help it would be appreciated.
Question
dbkincaid
I have some sort of target conflict when using my Digital Discovery and my Xilinx ZCU-104 board. The Xilinx board will not properly reset and detect from the SDK tool (Hardware Manager works, but I have to run my project from SDK)
I have not had any problems with conflict when using my Zybo Z7 with the Digital Discovery.
At this time, to get my target running I have to disconnect the Digital Discovery then Initialize the ZCU board. After it has started I can reconnect my Digital Discovery and it works as expected.
This workaround is not very good, plugging and unplugging hardware all the time. Also, the digital inputs (from ZCU to DD instrument) will partially back-power the Digital Discovery, so I have to disconnect all incoming signals to actually get the Digital Discovery to initialize and connect to the Waveforms tool.
If you could offer some suggestion or help it would be appreciated.
Brian
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.