How to Configure Pmod BT2 as a Slave with HC05 which is connected with arduino

[Abdul Qayyum]

Hi,

I am working on a project in which i want to send signal from Arduino board to Zybo . For this purpose i want to connect the HC05 with Pmod BT2. I go through from Pmod BT2 reference manual but i did not find any thing which is used to configure Pmod as master slave. 
Kindly tell me how to configure Pmod as master or slave while dealing with HC05 with Arduino?

[jpeyron]

Hi @Abdul Qayyum,

On the resource page for the Pmod BT2 here.We have tutorial How to Auto-Connect 2 PmodBT2's Together which describes the process of configuring the Pmod BT2 as a master or slave.

thank you,

Jon

[Abdul Qayyum]

I am unable to go in configuration mode of Pmod BT2 in SDK terminal as well as putty and Tera Term, where i can give commands. Due to which i am unable to configure them as master and slave. 
Can you help me. 

Thanks, 

AQ
 

[jpeyron]

Hi @Abdul Qayyum,

Here is a more advanced user guide that should help you with configuring the Pmod BT2.

thank you,

Jon

[Abdul Qayyum]

Thank you Sir