i'm using Max32 board for a test bench, it works perfectly but when i turn off ( No power ) on Max32 i should re pre-built software on board following Tools>Maker Hub> Linx firmware wizard.
Is there a solution to maintain the software on board also after power off, or is there a way to prebuilt using linx toolbox under my code on the starting of my program?
Question
raouf
Hello
i'm using Max32 board for a test bench, it works perfectly but when i turn off ( No power ) on Max32 i should re pre-built software on board following Tools>Maker Hub> Linx firmware wizard.
Is there a solution to maintain the software on board also after power off, or is there a way to prebuilt using linx toolbox under my code on the starting of my program?
Thanks a lot
Raouf
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.