Pavel_47 Posted November 8, 2018 Share Posted November 8, 2018 Hello, On Zybo board there are 6 Pmod connectors: A ... F. But when I open "Board" tab in Vivado I see only 5. F is missing. Any comments ? Thanks Link to comment Share on other sites More sharing options...
Notarobot Posted November 8, 2018 Share Posted November 8, 2018 The JF connector is physically connected to MIO ports. These ports allows to connect such peripheral as UART and CAN to PS. Configuration of such connections is done in the processing_system7_0 block in Vivado. In my understanding they are not present in the block design because there is no easy way to utilize it with PL. It is always helpful to check the schematic diagram of the board. Hope I've answered your question. Link to comment Share on other sites More sharing options...
Bianca Posted November 8, 2018 Share Posted November 8, 2018 Hi @Pavel_47, JF connector is routed to the MIO pins in the PS side of the ZYNQ. This is why you won't find it on the Block Design. You can access it by connecting the pins in the processing system to an interface you desire. Best regards, Bianca Link to comment Share on other sites More sharing options...
Question
Pavel_47
Hello,
On Zybo board there are 6 Pmod connectors: A ... F.
But when I open "Board" tab in Vivado I see only 5. F is missing.
Any comments ?
Thanks
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.