xdwsmswin Posted September 5, 2018 Share Posted September 5, 2018 In short: Is PmodMicroSD compatible with Cerebot MX4cK board? The reason I ask this is that, I was trying to make this Pmod module work on MX4cK by following steps: 1. Connect PmodMicroSD to JB connector on MX4cK 2. Use Arduino 1.8.6 with chipKIT core (also tried Digilent Core), try to initialize the SD library The code and the result is like this: As you can see, the value after SD init is always 0. Of course the file write statements at the end of setup() is not executed, either. I am just wondering, is my MX4cK board too old to use this Pmod module? Link to comment Share on other sites More sharing options...
jpeyron Posted September 5, 2018 Share Posted September 5, 2018 Hi @xdwsmswin, I do not believe that the MX4ck is too old to use the Pmod MicroSD. Have you tried using the arduino code from here which is using the Arduino uno as shown here? thank you, Jon Link to comment Share on other sites More sharing options...
xdwsmswin Posted September 9, 2018 Author Share Posted September 9, 2018 On 9/5/2018 at 11:21 AM, jpeyron said: Hi @xdwsmswin, I do not believe that the MX4ck is too old to use the Pmod MicroSD. Have you tried using the arduino code from here which is using the Arduino uno as shown here? thank you, Jon @jpeyron Yes. I did try it. Same result. Link to comment Share on other sites More sharing options...
jpeyron Posted September 10, 2018 Share Posted September 10, 2018 Hi @xdwsmswin, Can you attach a picture of how you are connecting the Pmod MicroSD to the MX4ck? Please attach the Arduino code you are using. thank you, Jon Link to comment Share on other sites More sharing options...
Question
xdwsmswin
In short: Is PmodMicroSD compatible with Cerebot MX4cK board?
The reason I ask this is that, I was trying to make this Pmod module work on MX4cK by following steps:
1. Connect PmodMicroSD to JB connector on MX4cK
2. Use Arduino 1.8.6 with chipKIT core (also tried Digilent Core), try to initialize the SD library
The code and the result is like this:
As you can see, the value after SD init is always 0. Of course the file write statements at the end of setup() is not executed, either.
I am just wondering, is my MX4cK board too old to use this Pmod module?
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.