vivado 2017.4

[Ram]

hi,,i am using vivado 2017.4 , sdk 2017.4.....but when i luanch program on hardware .......,sdk terminal is not showing any results...

can anyone pls tell me what is the problem behind it

[dpaul]

Quote

but when i luanch program on hardware

What do you mean?

Quote

sdk terminal is not showing any results..

Please define "not showing any results"

Can you please re-phrase your question for a better understanding of the problem?

 

[Ram]

like if we write printf(Axi gpio is initialize ),,,,or printf("hello world")    ..in our ''c' code ,,,sdk is not showing this

[jpeyron]

Hi @Ram,

Please attach a screen shot of your vivado block design as well as your sdk code. What development board are you using? What OS are you using on your PC? What buad rate do you have the terminal emulator set at?

thank you,

Jon

[Ram]

Hi,@jon

i am using zybo board , and i am working on windows 10 enterprise OS ,,baud rate= 115200,,,i choose lwip echo server from sdk template , i just make some modification into 

echo.c   code,, for using AXI GPIO ...i am attaching my block design and sdk code ,,please look over it ....

thanks for reply 

Ram,,,

ethernet_test_sdk_code.zip

[Ram]

Hey @jon

Pls , reply 

What can we do for this issue

Thanks

RAM

 

[Ram]

hey , anybody found any solution for SDK terminal

thanks 

Ram

[jpeyron]

Hi @Ram,

What is not working in your project? I have attached an altered echo.c that compares the input from the ethernet and prints specific text if the input is humidity or temperature. Hopefully this is helpful for your project.

thank you,

Jon

echo (3).txt

[Ram]

hi, jon

actually for a very first time when i create block design and use this c code (which i mentioned earlier )  , sdk was working , it was printing on sdk terminal ,, but after few hours , i use again this code , then it was not working ,, second time i am facing this problem , when i was using uart communication , i faced similar problem..........

 

thanks anyway .....

ram

[melisa]

Try disconneting your board, and connecting it again.
Then check in Device Manager on which port is your board,
and then connect it in SDK terminal. Program your board and then run your code.

I had similar issues and this fixed it. Hope it helps

 

[Ram]

On 8/8/2018 at 3:02 PM, melisa said:

Try disconneting your board, and connecting it again.
Then check in Device Manager on which port is your board,
and then connect it in SDK terminal. Program your board and then run your code.

I had similar issues and this fixed it. Hope it helps

 

Thank-you melisha ,,it is working

Ram