HARI Posted December 3, 2014 Share Posted December 3, 2014 Hi I am using Xilinx Platform USB cable II for programming CMOD S6 using iMpact Software. The connection picture is attached alongwith(connections.jpg) . But when I try to do Boundary scanning , it is showing some error .. also attached alongwith (iMpact error.jpg) Is there any specific document from where I can follow steps to program the CMOD S6 via JTAG or can you please provide some tips/instruction? Regards Hari Link to comment Share on other sites More sharing options...
cristian.ignat Posted December 4, 2014 Share Posted December 4, 2014 Hello, J4 connector is for USB microcontroller programming, so you cannot program FPGA using this connector. You can program the FPGA using the onboard programming solution using the microUSB connector. Cristian Link to comment Share on other sites More sharing options...
Question
HARI
Hi
I am using Xilinx Platform USB cable II for programming CMOD S6 using iMpact Software.
The connection picture is attached alongwith(connections.jpg) .
But when I try to do Boundary scanning , it is showing some error .. also attached alongwith (iMpact error.jpg)
Is there any specific document from where I can follow steps to program the CMOD S6 via JTAG or can you please provide some tips/instruction?
Regards
Hari
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.