Marty Posted July 12, 2018 Share Posted July 12, 2018 Its always on, even when I use USB communication, power toggle, or reset the board. How to Unistall WIFI firmware on Digilent WF32? Link to comment Share on other sites More sharing options...
Marty Posted July 12, 2018 Author Share Posted July 12, 2018 Reinstalling USB firmware wiped the WIFI firmware. Hurray! I'm back to only USB communication, which is a higher quality connection then the WIFI. When WIFI operates properly , it generates noise excess noise which may degrade quality of PMODs that perform low noise functions. It also is possible that if WIFI firmware is installed properly, but you are using USB to run your software, WIFI remains on and is pingable and generates noise which may reduce quality of some of your measurements. Also, if you install WIFI firmware with garbage settings, and then communicate using USB, you can get SPI read errors and analog in read errors which will shut down your measurements. Lost a half day with WIFI noise, hope others can avoid. Yes I was frustrated. Hurray its over. Link to comment Share on other sites More sharing options...
jpeyron Posted July 19, 2018 Share Posted July 19, 2018 Hi @Marty, Glad you were able to re-install usb firmware and the board works how you would like. cheers, Jon Link to comment Share on other sites More sharing options...
Question
Marty
Its always on, even when I use USB communication, power toggle, or reset the board. How to Unistall WIFI firmware on Digilent WF32?
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.