Walter C. Washington Posted February 3, 2016 Share Posted February 3, 2016 Dear Digilent, Upon review of your JTAG-SMT2 (Version 02 March 2015) datasheet; page-9 has an incomplete mechanical drawing. Page-9 falls to state total thickness (i.e. height or z-axis) dimensions. Only X-axis and Y-axis dimensions are provided in this datasheet. Utilization of your module in Anritsu designs require a complete mechanical drawing depicting all existing X,Y,Z-axis dimensions. Please send such information to Walter. Washington@Anritsu.com and/or call 408.778.2000 ext 1332 (Mon - Thrus) and 619.218.0531 (Fri - Sun). Thank You, Walter C. Washington Link to comment Share on other sites More sharing options...
JColvin Posted February 3, 2016 Share Posted February 3, 2016 Hi Walter C. Washington, I have asked some of our applications engineers to see if they are able to provide the z-axis dimensions for you. Thanks, JColvin Link to comment Share on other sites More sharing options...
TommyK Posted February 9, 2016 Share Posted February 9, 2016 Hi Walter, Thank you for pointing that out. It turns out we do have a Z measurement (2.640mm) for the JTAG-SMT2-NC, which is shipped without the micro USB port. The JTAG-SMT2 with the micro USB port measures out to be ~4.30mm. I will make sure this gets added into the documentation. Thanks, Link to comment Share on other sites More sharing options...
TommyK Posted February 9, 2016 Share Posted February 9, 2016 I should mention that this height was measured from the outside end of the micro USB port, the largest component on the board. Link to comment Share on other sites More sharing options...
Question
Walter C. Washington
Dear Digilent,
Upon review of your JTAG-SMT2 (Version 02 March 2015) datasheet; page-9 has an incomplete mechanical drawing.
Page-9 falls to state total thickness (i.e. height or z-axis) dimensions. Only X-axis and Y-axis dimensions are provided in this
datasheet. Utilization of your module in Anritsu designs require a complete mechanical drawing depicting all existing
X,Y,Z-axis dimensions. Please send such information to Walter. Washington@Anritsu.com and/or call 408.778.2000
ext 1332 (Mon - Thrus) and 619.218.0531 (Fri - Sun).
Thank You,
Walter C. Washington
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.