I check the Genesys 2 Kintex-7 FPGA Development Board schematics and found board provides 1.2V, 1.8 V, 2.5V, and 3.3V to banks connected to FMC. It is selected by jumper JP6. In my application I need 1.5V. Can I modify the resistor value so that I can have 1.5V instead of other values? Please advices, thank you.
Question
Tifei
I check the Genesys 2 Kintex-7 FPGA Development Board schematics and found board provides 1.2V, 1.8 V, 2.5V, and 3.3V to banks connected to FMC. It is selected by jumper JP6. In my application I need 1.5V. Can I modify the resistor value so that I can have 1.5V instead of other values? Please advices, thank you.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.