debugasm Posted January 9, 2016 Share Posted January 9, 2016 Hi, you can use the development board Zybo with "Hardware Cosim" in Xilin System Generator ? I can not understand that clock pin assigned because there is no clock directly connected to the PL of Zynq. Someone has succeeded ? Thanks very much. debugasm Link to comment Share on other sites More sharing options...
mwingerson Posted January 20, 2016 Share Posted January 20, 2016 Hello Debugasm, I am unaware of anybody being able to use Cosim with the ZYBO. I'm guessing the board files are not setup. Also there is a clock signal that drives just the PL section of the ZYNQ chip. If you check out the ZYBO ref manual, under "clock sources" it describes how the ethernet PHY IC produces the clock signal. If you get Cosim working with ZYBO, I would really like to hear about it! Best of Luck, Marshall Link to comment Share on other sites More sharing options...
Question
debugasm
Hi,
you can use the development board Zybo with "Hardware Cosim" in Xilin System Generator ?
I can not understand that clock pin assigned because there is no clock directly connected to the PL of Zynq.
Someone has succeeded ?
Thanks very much.
debugasm
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.