VVM-Maxcess Posted June 19, 2018 Share Posted June 19, 2018 Hello, can you provide a guidance on how to program CMOD S6 on board flash with my own project by using Xilinx ISE iMPACT? I went as far as generating and uploading code to FPGA RAM, tested it and now would like to program it in to the flash memory. Thank you in advance. Link to comment Share on other sites More sharing options...
jpeyron Posted June 19, 2018 Share Posted June 19, 2018 Hi @VVM-Maxcess, Here is a forum thread the discusses how to program the Cmod S6. thank you, Jon Link to comment Share on other sites More sharing options...
VVM-Maxcess Posted June 21, 2018 Author Share Posted June 21, 2018 I did follow these instructions with no problem, but the actual programming, the very last step failed. Now my board CMOD S6 is not responding. Can you advice on how to recover it? Thank you. Link to comment Share on other sites More sharing options...
jpeyron Posted June 21, 2018 Share Posted June 21, 2018 Hi @VVM-Maxcess, Are you able to see the Cmod S6 in the device manager in ports and universal serial bus controller? Please download Adept 2 here. Is adept 2 able to recognize the Cmod S6? Here is the Cmod S6 resource center. The Cmod S6 factory-loaded demonstration project on the Cmod S6 resource center is a verified project to test the Cmod S6. thank you, Jon Link to comment Share on other sites More sharing options...
VVM-Maxcess Posted June 22, 2018 Author Share Posted June 22, 2018 Jon To answer your questions - I can see the Diligent USB Device in the Device Manager, and in the Adept. The chain initialize goes trough, I can program .bit file, but the SPI Flash fails to program. Here is the screen shot. Link to comment Share on other sites More sharing options...
VVM-Maxcess Posted June 22, 2018 Author Share Posted June 22, 2018 Jon I tried to repeat all SPI flash programming steps and made a "progress", however it still fails to program, just hangs up in this screen: I was waiting 10 minutes, and got 1% of progress. Is this normal? I will wait as much as I can to see what will happen... Link to comment Share on other sites More sharing options...
VVM-Maxcess Posted June 22, 2018 Author Share Posted June 22, 2018 It took a while, maybe twenty minutes, but SPI flash memory works now. Thank you for your support, Jon! Link to comment Share on other sites More sharing options...
jpeyron Posted June 25, 2018 Share Posted June 25, 2018 Hi @VVM-Maxcess, Glad to hear you are able to program the flash on the Cmod S6. cheers, Jon Link to comment Share on other sites More sharing options...
Question
VVM-Maxcess
Hello, can you provide a guidance on how to program CMOD S6 on board flash with my own project by using Xilinx ISE iMPACT?
I went as far as generating and uploading code to FPGA RAM, tested it and now would like to program it in to the flash memory.
Thank you in advance.
Link to comment
Share on other sites
7 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.