CKChan Posted November 25, 2014 Share Posted November 25, 2014 Hi, I’m using Digilent EEBoard trying to get 1MHz 0V to 4V square waveform from Analog Wavegen. My setting is amplitude 2V & offset 2V but actual output is still -2V to +2V square waveform. Anyone can help? Many thanks. Link to comment Share on other sites More sharing options...
attila Posted November 26, 2014 Share Posted November 26, 2014 Since with the EEboard Scope DC input you see the offset on AWG, it means this output signal is good. The problem is in wiring or your bench oscilloscope setup. Make sure the oscilloscope channel is set to DC mode and not AC. Link to comment Share on other sites More sharing options...
attila Posted November 26, 2014 Share Posted November 26, 2014 Make sure to connect ground between the EEboard and oscilloscope, probe shield to EE GND pin. The ground of the EEboard is connected to the computer through the USB cable. In case you are using laptop or other mobile device, probably its ground is floating because the switching supplies usually don't have the wall plug grounding wired to the DC output V-. Such floating ground acts as an AC filter. Link to comment Share on other sites More sharing options...
attila Posted November 25, 2014 Share Posted November 25, 2014 Hi, Make sure you connect the AWG output to Scope DC input and not to AC. The later one removes the DC component of the input signal. Link to comment Share on other sites More sharing options...
CKChan Posted November 26, 2014 Author Share Posted November 26, 2014 Hi, Scope DC input is showing correct waveform (0 to 4V) but my oscilloscope is showing -2V to 2V. Link to comment Share on other sites More sharing options...
CKChan Posted November 26, 2014 Author Share Posted November 26, 2014 Hi, I'm using laptop. I connected the oscilloscope probe GND to EE board power supply GND. But my oscilloscope is showing -2V to 2V waveform. Link to comment Share on other sites More sharing options...
CKChan Posted November 27, 2014 Author Share Posted November 27, 2014 Hi, noted. thanks Link to comment Share on other sites More sharing options...
Question
CKChan
Hi, I’m using Digilent EEBoard trying to get 1MHz 0V to 4V square waveform from Analog Wavegen. My setting is amplitude 2V & offset 2V but actual output is still -2V to +2V square waveform. Anyone can help? Many thanks.
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.