Connect two Pmods to the same port

[Nachiket Karve]

I recently started working on the zybo z7-10 board. I have two pmods - the PmodGPS and the PmodCON3. Both of these pmods have 6 pins each and I want to connect both of these pmods to the same port on the fpga. However, I could not connect the PmodGPIO_0 and the PmodGPS_0 blocks to the same port in my Block Design in Vivado. Is there any way to do this?

[BogdanVanca]

Hello @Nachiket Karve,

Have you tried to connect them manually in the xdc file?.

Thank you,

Bogdan