allthingz Posted May 14, 2018 Share Posted May 14, 2018 Just got a WF32 board and when I connect to either J1 or J12, no COM port is shown. Downloaded FDTI and chipkit drivers without change. LD3 is solid and LD6 is blinking. Anyone have a suggestion? Link to comment Share on other sites More sharing options...
Larry Standage Posted May 14, 2018 Share Posted May 14, 2018 J1 is the correct port to use for the COM port. Make sure the USB cable you're using is both data and power. I've seen cables that are power only, and that would prevent the PC from seeing it. Link to comment Share on other sites More sharing options...
Question
allthingz
Just got a WF32 board and when I connect to either J1 or J12, no COM port is shown. Downloaded FDTI and chipkit drivers without change. LD3 is solid and LD6 is blinking. Anyone have a suggestion?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.