I've synthesised and generated the bitstream OK for the ARTY GPOI demo, but when I try to connect to the board using the Hardware Manager I get the following error message:
[Labtoolstcl 44-26] No hardware targets exist on the server [TCP:localhost:3121] Check to make sure the cable targets connected to this machine are properly connected and powered up, then use the disconnect_hw_server and connect_hw_server commands to re-register the hardware targets.
I've tried different USB ports with the same result.
Question
Leon Heller
I've synthesised and generated the bitstream OK for the ARTY GPOI demo, but when I try to connect to the board using the Hardware Manager I get the following error message:
I've tried different USB ports with the same result.
Is the board faulty?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.