Search the Community

Showing results for tags 'zybo-7010'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I am trying to run the "Hello world" program on my Zynq 7000 family board. The issue which is happening is i am not able to see the output of the program on my Terminal. I am using the SDK terminal for seeing the output. I have already gone through some videos from xilinx on SDK and i am following the same steps as they did. One day before, it was working fine but, i am really unable to figure out what is the issue now. I am a kind of a newbee in using Viavado and SDK, so it will be really great if some one can help me out. I am using Vivado 2019.1. So these are the steps which i am following: 1) Created a block diagram in Vivado and generated the bitstream. We can see that i am using UART1 and GPIO in peripherals. 2) Then I launched SDK from Viavdo and Created a new Application project. Then i used the "Hello world" template and created the BSP. 3) I created a "Run configuration", connected my terminal, Programmed my FPGA and then Launched the program on Hardware. Please let me know if any other information is needed. Thanks Amol