Search the Community

Showing results for tags 'zu'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments and the WaveForms software
    • LabVIEW
    • FRC
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Joined

  • Start

    End

Group

AIM

MSN

Website URL

ICQ

Yahoo

Jabber

Skype

Location

Interests

Found 1 result

  1. pfuhrman
    I have a Genesys ZU Rev. B board which comes up fine except the PMCU LED does not come on or blink at all, as it says in the reference manual. Nor can I turn on VADJ by outputting on the LEVEL0/1 and VADJ_AUTON signals from the 3EG chip. I have tried communicating with the ATMega over its serial port, but I get no response. For example, "0301" should return the firmware version. I have a logic analyzer on J36 to observe the startup I2C activity from the PMCU, but I see no activity at main power-on. I'm assuming that the PMCU is working since the ZU3EG comes up, but I also need