Search the Community
Showing results for tags 'zcu102'.
I'm trying to use Pcam FMC with a ZCU102. I've looked through this post so I know there may be a way forward by editing the netlist using post synthesis constraining. Because the I2C switch select lines are grounded on the ZCU102, I can only communicate with CAMA so going to use this as a one camera interface. I've also verified the IO requirements and other architecture requirements. So far, I don't see anything stopping me from using to interface with camera A with a ZCU102. However, I want to use the MIPI D-PHY Xilinx IP but need help with the configuration. Looking through the timing
Hi, I need to purchase a replacement power supply for a Xilinx Eval Board (the ZCU102). I came across the following Xilinx Answer Record (AR #67507): https://www.xilinx.com/support/answers/67507.html. This Answer Record is currently saying that a power supply can be purchased through Digilent. I have looked up the part numbers listed (6003-300-000, PW174KB1251, PW174KB1251FXX) on the Digilent website, but they do not show up. The only thing I found which came close was the following, but it seems to have a PCIe pinout and specifically says "Not for use with Xilinx® development boards
Hi, Im trying to catch an interrupt from an AXI GPIO switch from my board ZCU102. I have created the following design in Vivado: The design is validated so now im using Petalinux to boot linux. I have exported the .hdf file and built petalinux but i can't boot linux.It hangs after that: Exit from FSBL NOTICE: ATF running on XCZU9EG/silicon v1/RTL5.1 at 0xfffe5000 NOTICE: BL31: Secure code at 0xfffc0000 NOTICE: BL31: Non secure code at 0x8000000 NOTICE: BL31: v1.2(release): NOTICE: BL31: Built : 17:17:47, Dec 1 2016 [ 0.000000] Booting Linu