Search the Community
Showing results for tags 'z-turn'.
Hi, I have a MYIR Z-turn board with a Zc-7020 SoC. Recently, I bought an HS3 programming cable, however for some reason, I cannot get the HS3 to communicate with the Zynq7. I am using Vivado 2017.4. I already use the DLC9 programming cable and it is able to programme the PL part of the SoC however, I need the 100MHz clock to run and there is no documentation that show how to start the PS part using the DLC9 programming cable - that is why I bought the HS3 cable. Can anyone help please?
Hi, I'm kind of new to using external I/O connections on FPGA boards but I'm tasked with a project where I plan to interface a high-speed camera with 6 lvds pairs (4 data + 1 clock + 1 sync) with the clock input reaching up to 360 MHz, translating to a max data flow of 720Mbps through each of the 4 data pairs. Although this is the optimal operating condition, I don't necessarily have to achieve such speeds if I can get something close to that using an inexpensive board as low-cost is an important factor here. I was told to look at the following xilinx fpga boards with the Zynq 7000 series chip