Search the Community

Showing results for tags 'xup'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • New Users Introduction
    • Announcements
  • Digilent Technical Forums
    • FPGA
    • Digilent Microcontroller Boards
    • Non-Digilent Microcontrollers
    • Add-on Boards
    • Scopes & Instruments
    • LabVIEW
    • Other
  • General Discussion
    • Project Vault
    • Learn
    • Suggestions & Feedback
    • Buy, Sell, Trade
    • Sales Questions
    • Off Topic
    • Educators
    • Technical Based Off-Topic Discussions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 2 results

  1. Hi All, Is there anybody have any experience about XUP (Xilinx University Program) USB-JTAG Programmer Revision-G using with Vivado 2015 or 2018? I have some little experience with Vivado 2015.5 and 2018.1 but regarding my experiences XUP USB-JTAG Programmer is not compatible with Vivado? I tried all ways on Centos-7 OS and the particular script (install_drivers.tar.gz). I aimed to program the Zedboard for petalinux applications developing but no success with XUP USB-JTAG Rev.G and Vivado running on Centos-7. Could you please share any suggestions if you have? Regards. Kursat Gol
  2. Hi, I'm using Digilent's XUP USB-JTAG Programming Cable to program 'Z-turn board' which uses Xilinx Zynq-7000(http://www.myirtech.com/list.asp?id=502). There was no problem when I programed Bitstream or BBRAM through JTAG, but when I tried to program eFUSE Xilinx Vivado threw an error - ERROR: [Labtools 27-3277] jsn-DLC9LP-00000000000000 cable is not supported for EFUSE programming. Please use a Xilinx PCUSB2 DLC10 or approved Digilent cable I think my cable is approved one. Does anyone have any solution for this? Thank you in advance.